Controlling Other Tvs With The Remote Commander - Sony SLV-SE100A1, SLV-SE100A2 Operating Instructions Manual

To
Switch to/from wide mode of a Sony wide TV (For other
manufactures' wide TVs, see "Controlling other TVs with
the remote commander (SLV-SE300D1/D2 and SE480D
only)" below.)
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove the batteries
to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.

Controlling other TVs with the remote commander

(SLV-SE300D1/D2 and SE480D only)
The remote commander is preprogrammed to control non-Sony TVs. If your TV is
listed in the following table, set the appropriate manufacturer's code number.
1 Set [TV] / [VIDEO] at the top of the remote commander to [TV].
2
Hold down ?/1, and enter your TV's code number using the programme number
buttons. Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1, t TV/VIDEO, programme number buttons, - (ten's digit), PROG +/–,
2 +/–, WIDE*, MENU*,
* These buttons may not work with all TVs.
M / m / < / , *, and OK*.
Setting up the remote commander
Press
WIDE
continued
7