Controlling Other Tvs With The Remote Commander - Sony SLV-T2000MN Operating Instructions Manual

Setting the COMMAND MODE switch
To remotely control the Sony VCR
with this remote commander, set
COMMAND MODE on the
remote commander to the same
position as that on the VCR.
Usually set to VTR 3. Change the
position as shown below to
control other Sony VCRs:
VTR 1: For Sony Betamax format VCRs
VTR 2: For Sony 8mm format VCRs
VTR 3: For Sony VHS format VCRs

Controlling other TVs with the remote commander

The remote commander is
preprogrammed to control non-
Sony TVs. If your TV is listed in
the table on the next page, set the
appropriate manufacturer's code
number.
1
Set TV / VIDEO at the top of the remote commander to TV .
2
Hold down u , and enter your TV's code number(s) using the number
buttons. Then release u .
Now you can use the following TV control buttons to control your TV:
u (on/standby), TV / VIDEO , programme number buttons, PROG +/
–, VOL +/–, ; (TV), V (Teletext), FASTEXT buttons and WIDE with
some TVs.
COMMAND
MODE
u
TV /
VIDEO
continued
7
Getting Started