Operation; Remote Punch Eq (Option); Adjusting Gain - Rockford Fosgate T2500-1bd Installation & Operation Manual

REMOTE PUNCH EQ (Option)

NOTE: Previous (prior to 2007) Punch Bass and Para-Punch
remotes will not work with these amplifiers.
NOTE: Use the instructions that came with the
remote for a variety of mountings that fit
your preference.
Quick Install
1. Using the screws supplied, install the mounting
clip.
2. Slip the remote onto the mounting clip until it snaps into
place.
3. Route and connect the cable to the remote and amplifier.

Operation

4. Operation works the same as Punch EQ, see below.
NOTE: Connecting the optional remote overrides the Punch EQ
control on the amplifier.
CAUTION: Overexcursion and subsequent damage may occur at high levels of boost.
PUNCH EQ
Turning the knob clockwise increases the bass boost from 0 to +18dB @ 45Hz. Set this to your personal
preference while listening to the system.
NOTE: Connecting the optional remote overrides the Punch EQ control on the amplifier.

ADJUSTING GAIN

To adjust the gain setting, turn the amplifier gains all the way down (counter-clockwise).Turn the source unit
volume up until distortion is audible and then turn it down a bit until the distortion is inaudible.This will be
about all the way up on most source units. Next, increase the amplifier gain setting until adequate volume is
achieved.
NOTE:Best signal to noise and dynamic range are realized with the gain at minimum.
CAUTION: Avoid setting the amplifier gain very high as noise and distortion will
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.
increase significantly.
O
PERATION
+20
+18
+16
+14
+12
+10
+8
+6
+4
+2
-0
-2
20 50 100 200 500
LP
Hz
Low Pass
9