Rockford Fosgate T400X2ad Installation & Operation Manual
Power amplifier
Hide thumbs
Also See for T400X2ad:
- Operation manual (10 pages) ,
- Installation & operation manual (27 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Rockford Fosgate T400X2ad
Summary of Contents for Rockford Fosgate T400X2ad
- Page 1 AMPLIFIERS T400X2ad T400X4ad T500X1br Installation & Operation...
-
Page 2: Specifications
REAL POWER numbers, not inflated marketing ratings. ©2014 Rockford Corporation. All Rights Reserved. ROCKFORD FOSGATE and associated logos where applicable are registered trademarks of Rockford Corporation in the United States and/or other countries. All other trademarks are the property of their respective owners. Specifications subject to change without notice. -
Page 3: Design Features
The Speaker Terminals utilize 16 AWG 4-pin Molex quick connect wire connectors (+ and -). Remote Punch Level Control Remotely control the output level of the amplifier. (T400X2ad & T500X1br) Power/REM Terminals Signal Input The power and ground quick connector will accommodate The RCA inputs are capable of accepting signal from ei- 4 AWG, while the remote will accommodate 8 AWG.(The... -
Page 4: Installation Considerations
• Operation CD- (Test Tones & vehicle provides the best protection. Connector(s) - (T400X2ad & in good condition should be able to handle the extra load of any Prime wire into the REMOTE terminal and tighten the set screw to secure the... - Page 5 When using amplifiers on ATVs, Golf Carts or Motor- When using amplifiers on ATVs, Golf Carts or Motor- cycles, Rockford Fosgate recommends to run both cycles, Rockford Fosgate recommends to run both GND (negative) and B+ (positive) cables from the GND (negative) and B+ (positive) cables from the amplifier directly to the battery.
- Page 6 When using amplifiers on ATVs, Golf Carts or Motor- When using amplifiers on ATVs, Golf Carts or Motor- cycles, Rockford Fosgate recommends to run both cycles, Rockford Fosgate recommends to run both GND (negative) and B+ (positive) cables from the GND (negative) and B+ (positive) cables from the amplifier directly to the battery.
- Page 7 When using amplifiers on ATVs, Golf Carts or Motor- When using amplifiers on ATVs, Golf Carts or Motor- cycles, Rockford Fosgate recommends to run both cycles, Rockford Fosgate recommends to run both GND (negative) and B+ (positive) cables from the GND (negative) and B+ (positive) cables from the amplifier directly to the battery.
- Page 8 - PLC (if equipped) to the amplifier. Be sure to amplifier. The input sensitivity ranges from 150mV-12V to accommodate to the “ON” position for this feature to be active. The T400X2ad needs to Note: Use the 40Hz @ 0dB tone (Track 5) for mono amplifier applications maintain proper speaker polarity.
-
Page 9: Troubleshooting
Connect stereo directly to input of amplifier. If noise goes This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its away the unit being bypassed is the cause of the noise. - Page 10 Installation assistance available at www.rockfordfosgate.com/rftech 600 South Rockford Drive • Tempe, Arizona 85281 United States Direct : (480) 967-3565 • Toll Free : (800) 669-9899 R O C K F O R D F O S G A T E . C O M...