Sony HDW-M2100 Operation Manual page 22

2-2 Connector Panel
1 REF. (reference) VIDEO INPUT connectors
(BNC type) and 75Ω termination switch
Input a reference video signal. Input a three-valued
(positive and negative) sync signal, a video signal with
chroma burst (VBS) or a monochrome video signal
(VS). When using the loop-through connection set the
switch to the OFF position, and otherwise to the ON
position.
2 COMPONENT VIDEO OUTPUT connectors
(BNC type)
These connectors output analog component video
signals (Y/R–Y/B–Y).
3 COMPOSITE VIDEO OUTPUT connectors
(BNC type)
These connectors output analog composite video
signals.
When the setting of F4 (CHARA) in function menu
page 4 is ON, connector 3 (SUPER) outputs a signal
with superimposed time code, menu settings, alarm
messages, and other text information.
3 Digital audio output section
AUDIO OUTPUT(AES/EBU)
CH1/2 CH3/4
AUDIO OUTPUT (AES/EBU) connectors
AUDIO OUTPUT (AES/EBU) connectors (BNC
type)
Output a maximum of 4 sets (8 channels: CH1/2,
CH3/4, CH5/6, CH7/8) of AES/EBU format digital
audio signals.
2-14
Chapter 2 Location and Function of Parts
CH5/6 CH7/8
4 Digital signal output section
HDSDI
OUTPUT
1
2
1 HDSDI OUTPUT connectors
3(SUPER)
SDI SDTI
OUTPUT OUTPUT
1
2
1
3(SUPER) 2 SDTI OUTPUT connectors
2
3 SDI OUTPUT connectors
1 HDSDI (HD Serial Digital Interface) OUTPUT
connectors (BNC type)
These connectors output HD format video/audio
signals. When the setting of F4 (CHARA) in function
menu page 4 is ON, connector 3 (SUPER) outputs a
signal with superimposed time code, menu settings,
alarm messages, and other text information.
2 SDTI (Serial Data Transport Interface)
OUTPUT connectors (BNC type)
Output SDTI format video and audio signals.
3 SDI (Serial Digital Interface) OUTPUT
connectors (BNC type)
These connectors output D1 format video/audio
signals.
When the setting of F4 (CHARA) in function menu
page 4 is ON, connector 3 (SUPER) outputs a signal
with superimposed time code, menu settings, alarm
messages, and other text information.