Sony HDW-M2100 Operation Manual page 86

9-4 Items in the Extended Setup Menu
Item number Item name
501 STILL TIMER
502
TAPE PROTECTION
MODE FROM SEARCH
503 TAPE PROTECTION
MODE FROM STOP
504 DRUM ROTATION IN
STANDBY OFF
505 STILL TENSION
Menu items in the range 600 to 650, relating to the time code generator
Item number Item name
601 VITC POSITION SEL-1
(Invalid in 24PsF or
23.98PsF mode.)
9-16
Chapter 9 Setup Menus
Menu items in the range 500 to 599, relating to tape protection
Settings
Select the time delay from the tape transport stopping (either the "stop mode" or
the still playback mode in search mode) until the unit automatically switches to
the tape protection mode, in order to protect the video heads and the tape.
0.5S to 8M to 30M: Set the value in the range 0.5 seconds to 30 minutes.
Select the operation of the protection mode to protect the video heads and tape
when in the still playback mode in search mode (jog/shuttle).
STEP : Step forward at
STDBY: Switch to "Standby OFF mode" (the unit not on standby).
T.REL: Switch to tension release mode (the tape tension slackened).
Select the operation of the protection mode to protect the video heads and tape
when stopped (the "stop mode").
STDBY : Switch to "Standby OFF mode" (the unit not on standby).
T.REL: Switch to tension release mode (the tape tension slackened).
STEP: Step forward at
Select whether the drum rotates in "Standby OFF mode".
OFF : Drum does not rotate.
ON: Drum rotates.
Select the tape tension state in the still playback mode.
NORML : Normal tape tension is maintained during still playback mode, ready for
playback.
LOOSE: Reduce the tape tension further from the NORML setting. (Select
"LOOSE" when the unit is on standby for a long period of still playback, for
example, in a library management system (LMS).)
Note
When LOOSE is selected and the tape tension is reduced, playback cannot be
guaranteed.
Settings
In 59.94i, 29.97PsF mode
Select a line to insert the VITC in. (For SD output)
12H to 16H to 20H: Select any line from 12 to 20.
Note
You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.
In 50i, 25PsF mode
Select a line to insert the VITC in. (For SD output)
9H to 19H to 22H: Select any line from 9 to 22.
Note
You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.
1
/ normal speed every 2 seconds.
30
1 / normal speed every 2 seconds.
30
(Continued)