Table of Contents
Advertisement
Transferring Data between
Commanders (continued)
"ALL x" appears on the Mode
Display key, and "ALL" appears on
the left Label key.
4
Press the ENTER key.
During receiving the data,
"c c c c c c c c" flashes.
When all the data has been
successfully transferred, "ALL"
appears on the right Label key.
Notes
• If the Commander is not ready for
receiving the data, press the CLEAR key,
then press the RETURN key to clear all
the learned signals.
• If "NG" appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending Commander
again to send data.
60
5
Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the previous
setting mode.
To receive the data of a
Component Select button or key
from another remote
commander
1
Perform Steps 1 and 2 on page 59.
2
Press the COMPO key.
COMPO
"COMPO x" appears on the Mode
Display key.
Hide quick links:
Advertisement
Table of Contents
