Using The Option Button - Sony RM-AV2000 Operating Instructions (primary manual) Operating Instructions Manual

Using the OPTION
button
You can use the OPTION button as an
extra Component Select button.
For example, if you have two CD players,
you can set the remote control signals of
the second CD player to the OPTION
button to select its key operation.
To use the OPTION button, first assign a
component on it. Then you can either use
it as it is with a Sony component, set a
component code (page 8), or "teach" the
keys and buttons necessary remote
control signals (page 15).
RESET
LEARN NG
C+C- V+ V-
MU
1 2 3
D.SKIP
4 5 6
7 8 9
0
+10
CLEAR
ENTER
SYSTEM CONTROL
1 2 3
TV VCR1 VCR2
AMP CD MD/DAT
POWER
CD
3
PGM
CONTINUE
REPEAT
SHUFFLE
COMMANDER
1
LIGHT
OFF
VCR3 DVD DBS/CBL
DECK B/A TUNER OPTION
CHANNEL VOLUME
+ +
±
– –
≠
MUTING
2
Example: To assign a CD player
(CD) to the OPTION button
1
While pressing COMMANDER
OFF, press OPTION.
COMMANDER
+
OFF
RESET
LEARN
When a component is already
assigned to OPTION, the component
name and learnable keys flash. To
perform learning, skip to Step 3.
2
While pressing OPTION again,
press the desired Component
Select button.
+
OPTION
The Commander beeps, and the
Commander automatically goes into
learning mode (page 12).
RESET
LEARN NG
C+C- V+ V-
MU
1 2 3
D.SKIP
4 5 6
SUBTITLE
7 8 9
SOUND
FIELD
ON/OFF
0
+10
CLEAR
ENTER
When you assign an LD player
(VD) or a cable box (CBL)
Repeat this step again so that the desired
component ("VD" or "CBL") flashes.
When you assign a cassette deck
(DECK B/A)
You cannot assign both decks A and B to
the OPTION button at a time.
If the desired deck (A or B) is not displayed,
finish the procedure by pressing
COMMANDER OFF and press DECK B/A
to select the desired deck, and then start
over from Step 1.
OPTION
OP
CD
POWER
CD OP
DISPLAY
SLEEP ANGLE
PGM
GENRE MODE EXECUTE
RETURN CONTINUE
REPEAT
SHUFFLE
Continued
17