Adding An Extra Function To The Component Select Buttons; Programming The Power-On Command Of The Selected Component (For Sony Components Only) - Sony RM-AV2000 Operating Instructions (primary manual) Operating Instructions Manual

Adding an Extra
Function to the
Component Select
Buttons
Programming the Power-On
Command of the Selected
Component (for Sony
Components only)
When using Sony components, you can
program the Power-on signal for each
component on a Component Select
button. You can select the desired
component and power it on by just
pressing that Component Select button.
RESET
OFF
1
4
7
SYSTEM CONTROL
1
TV
AMP
24
LEARN NG TV
POWER
C+C- V+ V-
TV/VIDEO
DISPLAY
2 3
SLEEP
WIDE
5 6
8 9
MENU
EXECUTE
0
RECALL
P IN P
ENTER
COMMANDER
LIGHT
OFF
2 3
VCR1 VCR2 VCR3 DVD DBS/CBL
CD MD/DAT DECK B/A TUNER OPTION
CHANNEL VOLUME
+ +
±
– –
≠
MUTING
Example: To program the TV
button
1
While pressing COMMANDER
OFF, press VOLUME – and the
desired Component Select
button.
COMMANDER
OFF
When the Power-on command is
programmed, you will hear a beep
and "POWER ON" appears on the
display. (The display goes off when
you release the buttons.)
POWER
ON
To clear the Power-on command
Repeat the procedure above.
You will hear a beep and the following
display appears.
POWER
1
Notes
• When a signal has been already learned for a
Component Select button (see paga 25), the
Power-on command can not be programmed.
• When you program another signal using the
learning function to a Component Select
button (page 25) for which a Power-on
command has been already programmed, the
learned signal overwrites the Power-on
command. If the learned signal is cleared
afterward, the Power-on command will also
be erased and the button will return to its
status before being programmed.
VOLUME
+ +
–
TV