Table of Contents
Advertisement
07.02
Danger and
warning
information
Danger
!
S
S
S
S
S
S
Warning
!
S
S
S
Caution
!
S
S
S
Siemens AG 1999–2002 All rights reserved
SIMODRIVE sensor, Measuring System for Main Spindle Drives SIMAG H (PMH) – 07.02 Edition
Start–up/commissioning is prohibited until it has been ensured that the
machine, in which the components described here are to be installed, fufills
the regulations/specifications of the Directive 98/37/EC.
Only appropriately qualified personnel may commission/start–up this equip-
ment.
This personnel must observe the technical customer documentation rele-
vant to the product and the observe the danger and warning information.
Operational electrical equipment has parts and components which are at
hazardous voltage levels.
Hazardous axis motion can occur when working with the equipment.
All work should be undertaken with the system in a no–voltage condition
Perfect, safe and reliable operation of this equipment assumes that it has
been professionally transported, stored, mounted and installed as well as
careful operator control and service.
The information given in catalogs and quotations applies additionally for
special versions of machines and equipment.
In addition to the danger and warning information in the technical customer
documentation supplied with the equipment, all relevant national, local and
plant–specific regulations and specifications must also be taken into ac-
count.
For synchronous motors, voltage is present at the motor terminals when the
rotor is turning (integrated permanent magents).
Surface temperatures of over +100
reason, no heat–sensitive objects, such as cables or electronic compo-
nents, may be attached to or come into contact with the motor surface.
When handling cables, please observe the following:
– They must not be damaged
– They must not be stressed
– They must not come into contact with rotating components.
d
C can occur on the motors. For this
Preface
vii
Advertisement
Table of Contents
