Unpacking And Inspecting The Switch - Cisco Nexus 92348GC-X NX-OS Hardware Installation Manual

Installing the Switch Chassis
• Ensure that the site power meets the power requirements for the switch. If available, you can use an
• Ensure that circuits are sized according to local and national codes. Typically, this often requires one or

Unpacking and Inspecting the Switch

Before you install the switch, be sure to unpack and inspect the switch for damage or missing components.
If anything is missing or damaged, contact your customer service representative immediately.
uninterruptible power supply (UPS) to protect against power failures.
Caution Avoid UPS types that use ferroresonant technology. These UPS types can become
unstable with the switch, which can have substantial current draw fluctuations
because of fluctuating data traffic patterns.
both of the following:
• AC power supplies typically require at least a 15-A or 20-A AC circuit, 100 to 240 VAC, and a
frequency of 50 to 60 Hz.
Caution
To prevent loss of input power, ensure the total maximum loads on the circuits
supplying power to the switch are within the current ratings for the wiring and
breakers.
Note For AC input application, please refer to the statement below:
Warning Statement 1005 Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that the protective devices is rated not greater than 20A (North
America), 16A (Europe), and 13A (UK).
Note For DC input application, please refer to the statement below:
Warning Statement 1005 Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that the protective devices is rated not greater than 20A for
the regular DC power supplies (rated 48-60VDC) and 5A for the HVDC power
supplies.
Cisco Nexus 92348GC-X NX-OS Mode Switch Hardware Installation Guide
Unpacking and Inspecting the Switch
11