Related Manuals for ICP DAS USA NC-10TFT
Summary of Contents for ICP DAS USA NC-10TFT
- Page 1 Installation Guide 10BASE-T/10BASE-FL Ethernet Media Converter NC-10TFT / NC-10TFC Version 1.0, Oct/2004...
-
Page 2: Table Of Contents
Table of Contents 1. General Description………………………………………………P3 1.1 Specifications……………………………………………..…P3 2. Connectors & Cables……………………………………………..P4 2.1 10BASE-T UTP Cable……………………………………...P4 2.2 Fiber Optic Connector(Fiber Port)……………….………..P5 3. Installation………………………………………………………….P6 3.1 Install the media converter with the DC power supply…..P6 3.2 Making Network Connections………………………………P7 4. Interpreting LED Indicators………………………………………..P8 Version 1.0, Oct/2004... -
Page 3: General Description
-Power status -Link and receive status for TP port -Link and receive status for fiber port Fiber optic connectors: -Multimode ST : (NC-10TFT) -Multimode SC : (NC-10TFC) Environment: Temperature 0-50 Humidity 10-90% non condensing Dimensions : 26 x 150 x 125 mm (W x H x D) -
Page 4: Connectors & Cables
2 Connectors & Cables 10BASE-T RJ Connectors(TP Port) One RJ-45 connector is provided on the converter for 10BASE-T connection. For easy connection to any device using standard straight-through UTP cable, a push button is available to set the crossover function for the RJ-45. RJ-45 Pin MDI-X Jack MDI Jack... -
Page 5: Fiber Optic Connector(Fiber Port)
The following table lists the fiber connectors, fiber cables and the maximum length supported by each converter model : Model Connector Cable Used Cable Length* NC-10TFT NC-10TFC *Cable length : the maximum length in point-to-point full duplex operation Version 1.0, Oct/2004... -
Page 6: Installation
3 Installation 3.1 Install the media converter with the DC power supply Version 1.0, Oct/2004... -
Page 7: Making Network Connections
3.2 Making Network Connections The converters serve as a conversion path between two Ethernet devices. To both devices, the conversion is transparent. The connection could be one of the following configurations : Important rule : When a connection is established, make sure the devices located at both ends of the path are configured and operated using the same duplex mode and the maximum distance must comply with IEEE 802.3u specifications. -
Page 8: Interpreting Led Indicators
4 Interpreting LED Indicators The LED labeled “UTP” is used to indicate the status of the TP port and the LED labeled “FX” is for Fiber port. Status State Interpretation POWER Power status Converter is on. Converter is off. TP port link/Rx The UTP link is ok.