Assembling The Turntable; Setting The Voltage Selector (Only On Models Supplied With A Voltage Selector) - Sony PS-J20 Operating Instructions Manual

Getting Started

Assembling the Turntable

1
1
Place the rubber mat on the platter.
To make sure it operates properly, rotate the platter
clockwise once or twice with your hand.
Notes on installation
• Place the turntable on a level surface.
• Avoid placing the unit near electrical appliances (such as a
television, hair dryer, or fluorescent lamp) which may
cause hum or noise.
• Place the turntable where it will not be subject to any
vibration, such as from speakers, slamming of doors, etc.
• Keep the unit away from direct sunlight, extremes of
temperature, and excessive dust and moisture.
4
Setting the Voltage Selector
(Only on models supplied with
a voltage selector)
Check that the voltage selector is set to the local power
line voltage. If not, set the selector to the correct
position using a screwdriver.
1
Remove the dust cover.
2
Remove the lid, and set the voltage selector to the
local power line voltage using a screwdriver.
110–120V
220–240V
3
Replace the lid and close the dust cover.