Fitting Accessories; Collecting Cone; Weather Protection Housing; Sample Flow Housing - Honeywell 705 Series Operating Instructions Manual

MAN0362.P65 Issue 03, Mar 01
00705M5001
3.1 COLLECTING CONE (00780-A-0032)
To fit the Collecting Cone Assembly to a sensor, carry out
the following:
(1)
(2)
(3)

3.2 WEATHER PROTECTION HOUSING

To fit a Weather Protection Housing to a sensor carry out the
following:
(1)
(2)
(3)
3.3 SAMPLE FLOW HOUSING (00780-A-0035)
To fit a Sample Flow Housing to the sensor, carry out the
following:
(1)
(2)
(3)

3. FITTING ACCESSORIES

Remove the Filter Housing and gasket from the sensor.
Fit the Hydrophobic Barrier, ensuring that the white
surface faces away from the sinter.
Screw the Collecting Cone assembly onto the sensor
accessory thread and tighten firmly by hand.
(00780-A-2076)
Remove the Filter Housing and gasket from the sensor.
Fit the Hydrophobic Barrier, ensuring that the white
surface faces away from the sinter.
Screw the Weather Protection Housing on to sensor
accessory thread and tighten firmly by hand.
Remove the Filter Housing and gasket from the sensor.
Ensure that the Sample Flow Housing is fitted with its
gasket (00780-C-0017).
Apply a thin coating of anti-seize compound, such as a
light petroleum grease, to the sensor accessory thread.
16
705 Sensor