Configuration Extensions - Siemens Expert Series Operating Note

4

Configuration extensions

The KS 50-1 TCont configuration values are extended by the following settings
compared with the standard version
q Protocol selection
In configuration menu othr, item Prot is available for definition of the
protocol to be used.
othr
Name
Prot
q Output selection
Control of a pump can be selected via parameter PumPin the configuration menu
for OUT. 1 , OUT. 2 , OUT. 3 , OUT. 5 or OUT. 6 . The default is an active OUT.3.
OUT. 1 , OUT. 2 , OUT. 3 , OUT. 5 , OUT. 6
Name
PuMP
q Self-tuning start
For KS 50-1 TCont, the self-tuning behaviour during start-up was changed.
Self-tuning is suppressed during power-on and called up only when starting
control operation, if permitted (see OrEL).
Cntr
Name
Strt
Operating note KS 50-1 TCont
Range Description
Protocol selection for rear interface
0 MODBUS RTU
1 Protocol for tempering unit
2 Protocol for hot runner
Range Description
output pump
0 Not active
1 Active
Range Description
Self-tuning start
0 Manual self-tuning start via the front panel, or when starting
control operation, if permitted.
1 Manual self-tuning start via the front panel, when starting
control operation, if permitted, and when detecting
oscillation.
Configuration extensions
.
11
Default
1
Default
0
Default
0