Mitsubishi Electric SLZ Series Technical & Service Manual page 9

WIRELESS REMOTE CONTROLLER
D
B
A
C
OCH564
57
h
ON/OFF
TOO TOO
WARM COOL
FAN SELECT
AUTO COOL
VANE TIME
HEAT DRY
MODE
RESET
Installation area
• Area in which the remote controller is not exposed to direct sunlight
• Area in which there is no heating source nearby
• Area in which the remote controller is not exposed to cold (or hot) winds
• Area in which the remote controller can be operated easily
• Area in which the remote controller is beyond the reach of children
Installation method
1 Attach the remote controller holder to the desired location using 2 tapping screws.
2 Insert the lower end of the controller into the holder.
A Wireless remote controller (Accessory)
B Wall
C Remote controller holder (Accessory)
D Fixing screw (Accessory)
• The signal can travel up to approximately 7 meters (in a straight line) within 45
degrees to both right and left of the center line of the receiver.
In addition, the signal may not be received if there is interference of light of fluorescent
lights or strong sunlight.
9 9
17.5
Unit: mm