Siemens SIMATIC IPC377E Operating Instructions Manual page 79

Legacy USB support
You can enable or disable the USB support with the following steps:
1. Select Legacy USB support with the arrow keys and press Enter key.
2. Select Enabled, Disabled or Auto as you need and press Enter key in the pop-up window.
3. Press F4 key and save the change.
See the configuration options for Legacy USB support below:
Configuration
options
Auto
Enabled
Disabled
USB3.0 Port 1,USB3.0 Port 2 and USB2.0 Ports
You can enable or disable the USB Ports Per-port disable control with the following steps:
1. Select USB 3.0 Port 1 or USB 3.0 Port 2 or USB2.0 Ports with the arrow keys and press
Enter key.
2. Select Enabled/Disabled as you need and press Enter key in the pop-up window.
3. Press F4 key and save the change.
Note
If you select Disable on USB 2.0 Ports, all the USB2.0 ports cannot be used.
Hardware Monitor
In Hardware Monitor page, you can view and monitor the hardware status. See the hardware
monitor parameters below:
Configuration options
system temperature
CPU temperature
VCORE
+3.3V
+5V
+12V
VCC3V
VSB3
VBAT
SIMATIC IPC377E
Operating Instructions, 06/2019, A5E40965249-AD
Description
This option disables Legacy USB Support if there is no USB device is connected.
This option enables Legacy USB Support.
This option keeps USB device available only for EFI application.
Description
Show the temperature inside chassis.
Show the CPU temperature.
Show VCORE power voltage.
Show +3.3V power voltage.
Show +5V power voltage.
Show +12V power voltage.
Show VCC3V power voltage.
Show VSB3 power voltage.
Show VBAT power voltage.
Technical specifications
8.6 BIOS description
79