Wheel Assembly - Pet Gear PG8800 Instruction Manual

Step 1. Slide back wheel on axle as shown in
Figure A.
Step 2. Push in axel until it clicks.
Step 3. Pull on wheel to make sure
the wheel is engaged.
Repeat on other side.
When finished it should look like Figure B.
Step 4. Position stroller frame as shown in
Figure C.
Step 5. Place front wheels on stroller by
clicking them into the 6" posts on the bottom
of the stroller shown in Figure C.
Pull up to make sure wheels are locked.
Step 6. Take rear wheels (on axel with brakes)
and lock them into the 2" posts by placing leg
tube over the posts and pressing down until
they click (shown in Figure C).
Pull up to make sure wheels are locked.

WHEEL ASSEMBLY

Back Wheels
Inside
EXPEDITION PET STROLLER • PG8800
A.
B.
C.
D. Outside
Lock/Release Button
To remove front wheels,
press both release tabs.
To remove
axel press on
velco button.
To remove wheel, push
the lock/release button
(Figure D) and pull
wheel off.
3