Pet Gear PG8450NV Instruction Manual

Pet Gear PG8450NV Instruction Manual

Nv no-zip pet stroller
Hide thumbs Also See for PG8450NV:

Advertisement

For The ON-THE-GO Pet
INSTRUCTION MANUAL
NV NO-ZIP PET STROLLER
PG8450NV
Interior Dimensions:
30L x 13W x 22H
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
customerservice@petgearinc.com
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday

Advertisement

Table of Contents
loading

Summary of Contents for Pet Gear PG8450NV

  • Page 1 For The ON-THE-GO Pet ™ INSTRUCTION MANUAL NV NO-ZIP PET STROLLER PG8450NV Interior Dimensions: 30L x 13W x 22H To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.com Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday...
  • Page 2 Step 1. Release folding latch (A). Step 2. Spread handle (B) and seat apart until the frame clicks and locks on both sides. Step 3. Ensure that the stroller is locked in on both sides before using. NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 3 WARNING: Never leave your stroller parked without applying brakes. Canopy Back View of Stroller Step Here BACK WHEEL ASSEMBLY INSTRUCTIONS Shown with both back wheels in place. Push back wheels until they easily click into place. NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 4 FRONT WHEEL ASSEMBLY INSTRUCTIONS Step 1. To attach front wheel, slide plastic wheel Step 2. Slide wheel up, until velco pins pop out support up and into tubing. of holes. Velco Pin Velco Pin Tubing Tubing NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 5 Step 4. Remove cap on valve, then place stem onto valve and pump tire with handle. After tire is filled, place cap back onto valve. Step 2. Place inside opposite end. Cap/Valve Handle Pump Step 3. Twist on until tight. Stem NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 6 Step 2. Clip onto frame. TO SECURE LATCH Step 1. To close comparment, pull downward to latch clip onto frame. Step 2. Lift up on latch clip and secure by pushing down until it locks. NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 7 TO UNLOCK LATCH Pull upward on latch clip to release. TO SECURE SIDE FLAP To help secure compartment, Velcro flap around tube and fasten to the bottom of the compartment. NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 8 (D) rotate the folding mechanism almost 180 degrees forward until stroller releases and handle is lowered. SLIDE TO RIGHT SLIDE TO RIGHT AND ROTATE 180 DEGREES FORWARD WHILE SQUEEZING MAIN FRAME (D) LOCK RELEASE NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 9 • Clean the rear wheel assembly and the rest of the frame with warm, soapy water; clean off with warm water and dry thoroughly. • NOTE: Do not lubricate brake components or swivel locks. NV NO-ZIP PET STROLLER • PG8450NV...
  • Page 10 Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these warnings and the instructions could result in serious injury or death.

Table of Contents