Step 3: Presetting Radio Stations - Sony MHC-W555 Operating Instructions Manual

Step 3: Presetting
radio stations
You can preset up to 40 stations, 20 for FM, 10
for MW and 10 for SW.
1/u
4
(power)
DSP
CD
1
Press TUNER BAND repeatedly
until the band you want appears in
the display.
Every time you press this button, the
band changes as follows:
FM n MW n SW
2
Press and hold 0 – or ) + until
the frequency indication starts to
change, then release.
Scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
a stereo program) appear.
RELAY RELAY
t
DAILY 1 2 REC SLEEP DAILY 1 2 REC SLEEP
ß
1
DOLBY NR DOLBY NR
ALL DISC 1 S
PROGRAM PROGRAM
SHUFFLE SHUFFLE
REPEAT1 REPEAT1
1
2 5 3
DBFB
TUNED
STEREO
SUR
MONO MONO
SYNC SYNC
REC REC
STEP STEP
kHz kHz
VOLUME
MHz
3
Press TUNING MEMORY.
A preset number appears in the display.
RELAY RELAY
t
DAILY 1 2 REC SLEEP DAILY 1 2 REC SLEEP
ß
1
DOLBY NR DOLBY NR
ALL DISC 1 S
PROGRAM PROGRAM
SHUFFLE SHUFFLE
REPEAT1 REPEAT1
4
Turn the jog dial to select the preset
number you want.
5
Press ENTER/NEXT.
The station is stored.
6
Repeat steps 1 to 5 to store other
stations.
To tune in a station with a weak
signal
Press 0 – or ) + repeatedly to tune in the
station manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down the ENTER/NEXT
button, turn the power back on. When you change
the interval, AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Tip
The preset stations are retained for a day even if you
unplug the power cord or if a power failure occurs.
Preset number
TUNED TUNED
STEREO STEREO
SUR SUR
MONO MONO
SYNC SYNC
REC REC
STEP STEP
kHz kHz
VOLUME
7