Playing Only The Beginning Of Each Track - Sony MHC-G101 Primary Operating Instructions Manual

Programming the CD tracks
(continued)
4
Press )± or ≠0 to select a
track.
Selected track
1
PROGRAM
2 3
Selected disc
5
Press PROGRAM.
The track is programmed. The last
programmed track appears.
6
To program additional tracks,
repeat steps 3 to 5.
Skip step 3 if you select a track from the
same disc.
7
Press ·P.
All the tracks play in the order you
selected.
To
Program a pause
Stop play
Cancel program
play
Erase a track
from the end
Erase the entire
program
Tips
• The program you made remains after the Program
Play has finished. To play the same program
again, press ·P.
• "FULL" appears when you have programmed
more than 32 track numbers.
16
MHC-G101. 3-859-547-13. EN
PRESET EQ
FLAT ROCK POPS JAZZ
Press
·P
p
p
CLEAR on the remote in
stop mode
p for more than two
seconds
Playing only the
beginning of each track
— Music Scan
The begining of each track on all the CDs in
the CD tray play for 10 seconds.
To play only the begining of each
track
Press M. SCAN on the remote.
Track number blinks during the scanning.
To cancel music scan
Press M. SCAN on the remote again.
M.SCAN