Table of Contents
Advertisement
User Interface
DISPLAY SCREEN
4.2
The main measurement screen will be displayed three seconds after the power has been supplied
to the analyzer.
Figure 4.2: Main screen with the analyzer in stand-by mode.
When the control box starts up for the first time, the main display screen will appear.
If two sensors are connected/turned on, the measurement screen for two sensors will be
displayed as the main screen and the down arrow button can be used to scroll to the
sensor 1 or sensor 2 measurement screen.
If only one sensor is turned on, only the measurement screen of the sensor concerned will
be displayed and it will not be possible to scroll to a different screen.
If two sensors are connected and one or both do not give a measurement value, then a
dotted line will be displayed on the screen and the status message will change.
The current time and the operating mode (remote/local) will be displayed on the top line. A line –
XXXXXXXX – is displayed at the bottom of the screen where an alarm/message can be
displayed. If there is more than one alarm, then each one will be displayed in turn for 3 seconds.
The status of the O
OPERATING MODES
4.3
The possible operating modes of the 9065 are as follows:
INIT
Directly after the start up sequence from the control box the INIT-message will appear at the
bottom of the screen. The INIT-message means: The control box is receiving the calibration
data from the sensor (s). This will take between 30 and 60 seconds.
MEASURING
Depending on the number of sensors that have been connected, the following measurement
screens will be displayed
23
measurement is displayed on the bottom line.
2
Waltron User Manual
9065 Luminescent Dissolved Oxygen Analyzer
Advertisement
Table of Contents
