Fade In And Fade Out - Sony MDS-JE530 Operating Instructions Manual

Finely controlling the pitch (Fine Control
Function)
You can fine control the playback speed in 0.1%
increments from –98.5% to +12.5%.
1
While the deck is playing, press MENU/NO twice.
"Setup Menu" appears in the display.
2
Turn AMS (or press ./> repeatedly) until
"Pfine" appears, then press AMS or YES.
3
Turn AMS (or press ./> repeatedly) until the
desired value appears, then press AMS or YES.
4
Press MENU/NO.
Notes
• The playback sound drops out momentarily when you change
the fine control value.
• The fine control value reverts to "0%" (factory setting) when
you turn off the deck or eject the MD.
• The step and fine control values are linked; changing one value
also changes the other.

Fade In and Fade Out

You can use Fade-in Play to gradually increase the signal
level to the LINE (ANALOG) OUT jacks and the PHONES
jack at the start of playback. Fade-out Play gradually
decreases the signal level at the end of playback.
Fade-in Recording gradually increases the signal level at
the start of recording. Fade-out Recording gradually
decreases the signal level at the end of recording.
FADER
Note
The level of the signal output from the DIGITAL OUT connector
does not change during Fade-in Play nor Fade-out Play.
Fade-in Play and Fade-in Recording
During play pause (for Fade-in Play) or recording
pause (for Fade-in Recording), press FADER.
b flashes in the display and the deck performs Fade-in
Play or Fade-in Recording for five seconds (factory
setting) until the counter reaches "0.0s."
` / 1
A
FADER
X . >
H X
z x
. >
m M
41
GB