GMC Savana 2020 Owner's Manual page 143

142 Infotainment System
Using the Dial or Call
Command
1. Press and hold /
two seconds.
2. Say Dial or Call.
3. Say the entire number without
pausing, or say the name tag.
Once connected, the person called
will be heard through the audio
speakers.
Calling Emergency
1. Press and hold /
two seconds. The system
responds Ready, followed by
a tone.
2. Say Dial or Call.
3. Say [emergency number].
4. Say Dial or Call.
Once connected, the person called
will be heard through the audio
speakers.
Using the Digit Dial Command
The digit dial command allows a
phone number to be dialed by
for
entering the digits one at a time.
After each digit is entered, the
system repeats back the digit it
heard followed by a tone.
If an unwanted number is
recognized by the system, say
Clear at any time to clear the last
number.
To hear all of the numbers
recognized by the system, say
for
Verify at any time.
1. Press and hold
two seconds.
2. Say Digit Dial.
3. Say each digit, one at a time,
that you want to dial. After
each digit is entered, the
system repeats back the digit it
heard followed by a tone. After
the last digit has been entered,
say Dial.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
1. Press and hold
two seconds.
2. After the tone, say Re-dial.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
Press
/ for
Press
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
Press
incoming call when another call
is active. The original call is
placed on hold.
Press
the original call.
/ for
/ to answer the call.
/ to ignore a call.
/ to answer an
/ again to return to