Setting The Profibus Dp Address; Configuration Of The Addfem Soe - Siemens SIMATIC PCS 7 Operating Instructions Manual

Setting the PROFIBUS DP address

The process for setting the PROFIBUS DP address of the AddFEM SoE is the same as that
for the AddFEM and is described in the correspondingly named section in the
"AddFEM (Front End Module)" operating instructions. The document is available
under the following link:
Internet (http://www.siemens.com/automation/service&support)
2.1

Configuration of the AddFEM SoE

The configuration of the front-end function SoE is performed via a configuration tool, for
example HW Config with GSD tool. The SoE function can be configured with the GSD files
"SiT580A3.GS?" or "SiT680A3.GS?". You can find additional information about the GSD files
in the "Readme.pdf" file of the current Manuals&Drivers CD AddFEM.
Parameter assignment of the FEF SoE takes place exclusively via DP-V1 services. The data
records for the parameter assignment are transferred with write jobs to the AddFEM SoE.
Per AddFEM SoE, you can optionally connect:
● Up to 31 binary SoE channels or
● High-speed IO channels
Enable the SoE channels individually. A defined sequence does not have to be observed.
The channel enable as an SoE input should be specified during startup, but can also be
modified online.
The configuration specifies not only the binary inputs that are to be monitored, but also which
edge of the signal (0 → 1 or 1 → 0) is to be reported as "incoming" or "outgoing" edge. The
configuration of the signal edge to be taken into consideration takes place channel-
selectively in accordance with the PROFIBUS standard.
10
AddFEM Sequence of Event
Operating Instructions, 03/2016, A5E00075541X-06
2