Advertisement
STEP 10 - SECURE THE WIRES
Connect the wires from the amplifier or amplifier harness to the connectors on the back of the
pods, left and right. Do not let it fall behind the pod as you are mounting.
STEP 11 - MOUNT THE PODS
Remove any tape from the fenders. With the included hardware mount the pod. The bolt and 1
washer mount through the fender, into the pod. This leaves only the head of the bolt visible
behind the tire.
Make certain you use a washer on the inside against the internal wall of the pod against the
fender of the RZR. Use your ½ inch ratchet and wrench to secure the pod.
Mount the other RZR pod in the same manner.
For additional technical information on this and all MB QUART products, go to
the "SUPPORT" tab at MB QUART.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
©2018 Maxxsonics USA
Advertisement
