Sony CMT-M100MD Operating Instructions Manual page 42

Changing the recorded level after
recording (continued)
4
Press l or L (or . or > on
the remote) repeatedly until "Fade In?"
or "Fade Out?" appears, then press
ENTER/YES on the remote.
5
Press l or L (or . or > on
the remote) repeatedly until the track
number you want to change the
recording level appears, then press
ENTER/YES on the remote.
"Time 5.0s" appears.
6
While monitoring the sound, press l
or L (or . or > on the remote)
repeatedly to change the Fade-in or
Fade-out recording time.
The system plays the portion that will be
recorded over using Fade-in or Fade-out
Recording. You can set the time at any
value between 1.0 second and 15.0 seconds,
in 0.1 second steps. You cannot set the time
longer than the track.
7
Press ENTER/YES on the remote.
"S.F Edit OK?" appears.
8
Press ENTER/YES on the remote.
The deck starts recording over the existing
track. "S.F Edit: ** %" appears while the
track is being recorded. When the recording
finishes, "Complete!" appears.
To cancel the operation
Press MENU/NO on the remote during step 3
through 7. After recording starts in step 8, you
cannot interrupt the operation.
42
Notes
• Do not disconnect the mains lead or move the
system while recording is in progress. This may
damage the recording data preventing recording
from being performed properly.
• Do not use an MD that is damaged or dirty. This
may prevent recording data from being recorded
properly.
• Repeatedly changing the recording level results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it returned to the original level.
• The recording level cannot be changed while the
timer is activated.
• You cannot undo the S.F Edit Function even if you
use the Undo Function.