WARNING
WARNING
WARNING! Wear safety goggles when using this tool!
Wear Safety Goggles
Wear Safety Goggles
Avoid Contact with Refrigerant
Avoid Contact with Refrigerant
FLARING
FLARING
1. Make sure the flaring cone is securely attached to the yoke screw.
1. Make sure the flaring cone is securely attached to the yoke screw.
2. Insert an evenly cut piece of tubing into the corresponding sized
2. Insert an evenly cut piece of tubing into the corresponding sized die. Insert tubing so
die. Insert tubing so that it is slightly above the top of the die.
that it is slightly above the top of the die.
3. Tighten the wing nut closest to the tube first, then tighten the
3. Tighten the wing nut closest to the tube first, then tighten the other one. Nuts must be
other one. Nuts must be securely tightened so there is no chance
securely tightened so there is no chance of the tube slipping.
of the tube slipping.
4. Slide the yoke over the bar and line up flaring cone with tube.
4. Slide the yoke over the bar and line up flaring cone with tube. Slightly turn the yoke
Slightly turn the yoke clockwise to lock into place. Secure this
clockwise to lock into place. Secure this locked position with thumb and forefinger
locked position with thumb and forefinger and begin to tighten
and begin to tighten down the yoke screw until desired flare is achieved.
down the yoke screw until desired flare is achieved.
SWAGING
SWAGING
1. Remove yoke cone and install the proper size spreader on the yoke screw. Note that
the small spreader accommodates 3/16", 1/4" and 3/8" O.D. tubing.
1. Remove yoke cone and install the proper size spreader on the
yoke screw. Note that the small spreader accommodates 3/16",
2. Insert an evenly cut piece of tubing into the corresponding sized die. Insert tubing
1/4" and 3/8" O.D. tubing.
approximately 1/8" more than the size (O.D.) of the tube you are swagging. (i.e. on
1/2" O.D. tubing, the tubing should protrude 5/8" past the face of the bar).
2. Insert an evenly cut piece of tubing into the corresponding sized
die. Insert tubing approximately 1/8" more than the size (O.D.) of
the tube you are swagging. (i.e. on 1/2" O.D. tubing, the tubing
should protrude 5/8" past the face of the bar).
OPERATING INSTRUCTIONS
70053 FLARING AND SWAGING TOOL
INSTRUCTIONS FOR USING FLAR
Visit us at www.TestEquipmentDepot.com
"World Class Quality"
99 Washington Street
Melrose, MA 02176
Phone 781-665-1400
Toll Free 1-800-517-8431
�
70053
1