Recording To A Tape; Cd Synchro Recording/Recording Manually - Sony CMT-EP404 Operating Instructions Manual

Recording to a tape

— CD Synchro Recording/Recording Manually

You can record from a CD or radio. You can use TYPE I (normal) tape.
Steps Recording from a CD
(CD Synchro Recording)
1
Load a blank tape.
2
Press CD.
3
Load the CD you want to record.
4
Press z.
The deck stands by for recording.
When you want to record on the reverse side, press nN (CMT-EP505 only).
5
Press RDS/DIR (PLAY MODE/RDS/DIR on the remote) repeatedly to select g
to record on one side, h to record on both sides (CMT-EP505 only).
6
Press z again.
Recording starts.
To stop recording
Press x.
Tips
• For recording from a CD to a tape manually, you
can turn ./> clockwise or counterclockwise
(or press . or > on the remote) to select
tracks during recording pause mode (after step 4
and before step 6).
• When you record on both sides, be sure to start
from the front side. If you start from the reverse
side, recording stops at the end of the reverse side
(CMT-EP505 only).
• When an AM program is noisy while recording, set
the ISS switch at the rear of the unit to select the
position that most decreases the noise (CMT-EP404
only).
Recording from the radio
Press TUNER (TUNER/BAND on the
remote).
Tune in the station you want to record.
GB
15