Display; Using The Cd Display; Troubleshooting; Problems And Remedies - Sony CMT-EP404 Operating Instructions Manual

Display

Using the CD display

Press DISPLAY repeatedly.
The display changes as follows:
During normal play
Elapsed playing time on the current track t
Remaining time on the current track t
Remaining time on the current CD t Clock
display (for five seconds) t Elapsed playing
time on the current track t ...
In the stop mode
Total number of tracks and total playing time
t Clock display (for five seconds) t Total
number of tracks and total playing time t ...

Troubleshooting

Problems and remedies

If you have any problem using this system, use
the following check list.
First, check that the power cord is connected
firmly and the speakers are connected correctly
and firmly.
Should any problem persist, consult your
nearest Sony dealer.
General
The display or button remains lighted or flashes
even after the system was turned off.
• Press DISPLAY on the remote repeatedly until
the clock display appears.
The clock indication does not show the correct
time.
• A power interruption occurred. Set the clock and
timer settings again.
The clock setting/radio presetting/timer is
canceled.
• The power cord is disconnected or a power
failure occurs longer than half a day.
Redo the following:
— "Setting the clock" on page 7
— "Presetting radio stations" on page 10
If you have set the timer, also redo "Timer-
recoding radio programs" on page 16 and
"Waking up to music" on page 18.
There is no sound.
• Turn VOLUME clockwise and hold.
• The headphones are connected.
• Insert only the stripped portion of the speaker
cord into the SPEAKER terminal. Inserting the
vinyl portion of the speaker cord will obstruct the
speaker connections.
There is severe hum or noise.
• A TV or VCR is placed too close to the stereo
system. Move the stereo system away from the
TV or VCR.
The timer does not function.
• Set the clock correctly.
• You cannot activate the Timer-recording and
Daily Timer at the same time.
• When you used the Sleep Timer, Daily Timer
and Timer-recording will not turn on the system
until the Sleep Timer turns it off.
continued
GB
19