Table of Contents
Advertisement
2. Safety
This chapter lists all the generally applicable safety instructions and technical information. Furthermore, every
other chapter contains specific safety instructions and technical information. All instructions and information must
be observed and followed during the various phases of the product's lifecycle (installation, operation,
maintenance, transport etc.). The operator is responsible for ensuring that personnel follow these instructions and
guidelines.
2.1. Instructions and safety information
This manual uses instructions and safety information for preventing injury and damage to property.
To make this clear for the personnel, the instructions and safety information are distinguished as follows:
Each safety instruction begins with one of the following signal words:
Danger: Serious or fatal injuries can occur!
Warning: Serious injuries can occur!
Caution: Injuries can occur!
Caution (Instruction without symbol): Serious damage to property can occur, including irreparable damage!
Safety instructions begin with a signal word and description of the hazard, followed by the hazard source and
potential consequences, and end with information on preventing it.
2.2 Guidelines used and CE certification
Our products are subject to
- various EC directives
- various harmonized standards
- various national standards.
Please consult the EU Declaration of Conformity for the precise information and the guidelines and norms in
effect. The EU Declaration of Conformity is issued in accordance with EU Directive 2006/42/EEC, Appendix II A.
Also, various national standards are also used as a basis for using, assembling and dismantling the product.
These include the German accident prevention regulations, VDE regulations, German Equipment Safety Law etc.
The CE symbol is found either on the type plate or next to the type plate. The type plate is attached to the motor
casing.
2.3 General safety
•
Never work alone when installing or removing the product.
•
The machine must always be switched off before any work is performed on it (assembly,
dismantling, maintenance, installation). The machine must be disconnected from the electrical
system and secured against being switched on again. All rotating parts must be at a standstill.
•
The operator should inform his/her superior immediately should any defects or irregularities occur.
•
It is of vital importance that the system is shut down immediately by the operator if any problems
arise which may endanger safety of personnel. Problems of this kind include:
•
Tools and other objects should be kept in a place reserved for them so that they can be found
quickly.
•
Sufficient ventilation must be provided in enclosed rooms.
•
When welding or working with electronic devices, ensure that there is no danger of explosion.
•
Only use fastening devices which are legally defined as such and officially approved.
•
The fastening devices should be suitable for the conditions of use (weather, hooking system, load,
etc). If these are separated from the machine after use, they should be expressly marked as
fastening devices. Otherwise they should be carefully stored.
•
Mobile working equipment for lifting loads should be used in a manner that ensures the stability of
the working apparatus during operation.
•
When using mobile working equipment for lifting non guided loads, measures should be taken to
avoid tipping and sliding etc.
•
Measures should be taken that no person is ever directly beneath a suspended load. Furthermore, it
is also prohibited to move suspended loads over workplaces where people are present.
•
If mobile working equipment is used for lifting loads, a second person should be present to
coordinate the procedure if needed (for example if the operator's field of vision is blocked).
•
The load to be lifted must be transported in such a manner that nobody can be injured in the case of
a power cut. Additionally, when working outdoors, such procedures must be interrupted immediately
if weather conditions worsen.
36
Failure of the safety and/or control devices
Damage to critical parts
Damage to electric installations, cables and insulation.
Advertisement
Table of Contents
