O P E R A T I O N O F S T A N D A R D F E A T U R E S; Switch Panel - Grady-White Bimini 306 User Manual

3 0 6 B
I M I N I

O p e r a t i o n O f S t a n d a r d F e a t u r e s

S P
WITCH ANEL
At the helm you will find an accessory switch panel. Refer to the "Accessory Wiring Color –
Fuse/Breaker Sizes" on page 6–10 for overcurrent protection amperage ratings for each circuit.
Consult your dealer for specific information or questions on the accessories included on your
boat.
• Aft and Forward Bilge Pumps
These two-way switches serve as manual switches for each bilge pump. These switches
operate independently of each other. Two circuit breakers located above each switch provide
over-current protection at the panel for each bilge pump circuit.
• Cockpit Lights
The cockpit lights provide illumination in the cockpit. A circuit breaker located above this
switch provides over-current protection for this circuit.
• Electronics Box
This momentary switch activates the lift which opens and closes the raisable electronics box
at the helm. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Horn
This momentary switch activates a horn which meets the requirements of the USCG for
sounding devices. A circuit breaker located above this switch provides over-current protection
for this circuit.
• Livewell
This switch activates the livewell pump and light. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Navigational/Anchor Lights
This three-position switch (NAV-OFF-ANC) changes the lighting configurations to running or
anchor lights. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Spreader Light
This switch activates the aft hard top spreader lights. A circuit breaker located above this
switch provides over-current protection for this circuit.
• Trim/Tilt
The trim/tilt switch is located on the throttle control. Trim changes the angle of thrust of the
engine(s) (reference "Trim" on page 4–1). Tilt raises the drive unit for trailering.
• Trim Tab
These switches control the hydraulic trim tabs used for adjusting the attitude of the boat. See
"Trim Tabs" on page 8–8 for more details.
• Washdown
This switch activates the washdown system. A circuit breaker located above this switch
provides over-current protection for this circuit.
8–2