Advertisement
G G . . 4 4 . . 1 1
A A D D J J U U S S T T M M E E N N T T O O F F T T H H E E M M I I N N I I M M A A L L D D I I S S T T A A N N C C E E
B B E E T T W W E E E E N N T T H H E E G G L L A A S S S S A A N N D D T T H H E E U U P P P P E E R R
P P L L A A T T E E ( ( m m o o d d e e l l s s e e q q u u i i p p p p e e d d o o n n l l y y ) )
If 0 chock: H = approximately 13mm
If 1 chock: H = approximately 24mm
If 2 chocks: H = approximately 35mm
If 3 chocks: H = approximately 46mm
If 4 chocks: H = approximately 57mm
NOTE!
THE NUMBER OF CHOCKS IS GIVEN STARTING
FROM THE TOP (SEE EXAMPLE)
• 4 4 C C H H O O C C K K S S
• 2 2 C C H H O O C C K K S S
G G . . 5 5
W W o o r r k k p p l l a a c c e e
All the laws, regulations and directives in force in the place of
installation regarding the following must be observed.
• Correct lighting of workplaces.
• Safety in the workplace, accident prevention.
• Compulsory signs and signals.
• Hygiene.
• Work zones and separation of paths for hygienic purposes.
• Fire prevention.
• Low air pollution emissions.
G G . . 6 6
U U n n p p a a c c k k i i n n g g
I I M M P P O O R R T T A A N N T T
Immediately check for any damage
caused during transport. Inspect the pack-
aging before and after unloading.
• The forwarder is responsible for the goods during transport
and delivery.
• Make a complaint to the forwarder in case of visible or
hidden damage.
• Specify any damage or shortages on the dispatch note.
• The driver must sign the dispatch note: the forwarder can
reject the claim if the dispatch note is not signed (the
forwarder can provide the necessary form).
• For hidden damage or shortages becoming apparent only
after unpacking, request the forwarder for inspection of the
goods within and no later than 15 days after delivery.
• Keep all the documentation contained in the packaging.
• Remove the packaging. Take care when unpacking and
handling of the appliance to not cause any shocks on itself.
G G . . 6 6 . . 1 1
F F e e e e t t i i n n s s t t a a l l l l a a t t i i o o n n
G G . . 7 7
E E l l e e c c t t r r i i c c a a l l c c o o n n n n e e c c t t i i o o n n
W W A A R R N N I I N N G G
Refer to " Safety Information ".
I I M M P P O O R R T T A A N N T T
Connection to the power supply must be
carried out in compliance with the regu-
lations and provisions in force in the
country of use.
• Make sure the system power supply is arranged and able to
take the actual current load and that it is executed in a
workmanlike manner according to the regulations in force in
the country of use.
• The plug must be accessible after positioning the appliance
in the place of installation. Make sure the plug is not crushed
by the appliance. A damaged power cable can overheat and
catch fire or cause a short circuit.
• Make sure the machine power supply voltage specified on
the data plate matches the mains voltage.
• Make sure that the socket has an efficient ground contact.
x4
A
B
1
x4
B
A
2
19
Advertisement
