Introduction; General; References; Safety - Martin M3910 Operator's Manual

Introduction

General

References

Safety

Materials required

Martin Engineering M3910-04/19
®
Martin Electric Vibrators (M Series) are designed and manufactured to
ensure the best performance and reliability in severe-duty applications. The
vibrator motor has a recommended operational ambient temperature and
mounting surface temperature range of -22 to 104°F (-30 to 40°C). If
operating the motor in environments beyond these temperatures, call Martin
Engineering, as the vibrator may require rating reduction, more frequent
lubrication, or lubrication substitution.
The vibrators in this manual may be referred to by their model numbers or
part numbers. Table VI in the "Part Numbers" section provides model
numbers and part numbers together with frame size. The following letter
designations are used throughout this manual:
®
• MM (Martin Vibrator bolt pattern).
®
• MC (Cougar Vibrator bolt pattern)
• MI (Invicta Vibrator bolt pattern)
®
• MV (Vimarc Vibrator bolt pattern)
®
• MU (Uras Vibrator bolt pattern)
®
• MB (Bosch Vibrator bolt pattern)
The following documents are referenced in this manual:
• The National Electrical Code (NEC), National Fire Protection Association,
1 Batterymarch Park, P.O. Box 9101, Quincy MA 02269-9101.
• American National Standards Institute (ANSI) z244.1-1982, American
National Standard for Personnel Protection - Lockout/Tagout of Energy
Sources - Minimum Safety Requirements, American National Standards
Institute, Inc., 1430 Broadway, New York, NY 10018.
• Code of Federal Regulation (CFR) 29, Part 1910, Control of Hazardous
Energy Source (Lockout/Tagout); Final Rule, Department of Labor,
Occupational Safety and Health Administration (OSHA), 32nd Floor, Room
3244, 230 South Dearborn Street, Chicago, IL 60604.
• CFR 29, Part 1910.15, Occupational Noise Exposure, Department of Labor,
OSHA, 32nd Floor, Room 3244, 230 South Dearborn Street,
Chicago, IL 60604.
All safety rules defined in the above documents and all owner/employer safety
rules must be strictly followed when working on the vibrator.
In addition to metric hand tools, the following materials are required to install
this equipment:
• Rigid beam or mounting plate.
®
• Martin BBAC Cable Kit, P/N 32271, or equivalent.
(Mount Kit for Electric Vibrators, P/N 32401-XX includes W-beam Mount,
mounting hardware, and Martin
1
®
BBAC Safety Cable Kit.)
®
Martin Electric Vibrators