Table of Contents
Advertisement
A.
D-ring
B.
Structure wall
C.
Wire cable
Vibrator lifting eye
D.
E.
D-ring on W-beam
F.
Cable clamp (6)
Martin Engineering M3910-04/19
If vibrator is mounted more than 6 in. (152 mm) above
ground, install cable securing vibrator to structure. Without
cable, vibrator could fall and cause injury.
7. Secure vibrator to structure by installing Martin
P/N 32271, or equivalent as follows (cable is included with Mount Kit for
Electric Vibrators, P/N 32401-XX):
C
E
F
D
Figure 4. Installing Restraining Cable
a. Weld D-ring (A, Figure 4) onto structure wall (B) above vibrator.
b. Loop 1/4-in. (6 mm) wire cable (C) through vibrator lifting eye (D)
and D-ring on structure wall.
®
c. If using a Martin
W-beam (E) as shown. Take up slack so cable is taut.
d. Apply thread-sealing compound to nuts on cable clamps (F). Install six
cable clamps (two on each end and two on loop around D-ring on
W-beam) to secure cable to vibrator eye and D-rings. Torque nuts on
cable clamps according to drawing 32401-XX supplied with Mount
Kit for Electric Vibrators.
e. Trim loose ends of wire cable.
7
WARNING
!
A
B
B
W-beam Mount, also loop cable through D-ring on
®
BBAC Cable Kit,
®
Martin
Electric Vibrators
Advertisement
Table of Contents
