Using The Password - Sinclair SCMI-01.4 User Manual

Press the ENTER key to enter the main menu for module setting, when the default screen is
displayed. This menu consists of the following items (submenus).
Goal C
Goal H
Function
Defrost
Outputs
Reg.cons
Display
Password

4.1. Using the Password

The access to the module settings is protected by a six-digit password (201201), which
must be entered in advance (to log on). If you try to change settings without logging, the
display returns one level back. Under the default settings of the SCMI-01.4 control module,
you can only change the display backlight and contrast without logging in. Once the module
is connected to the USB port of the computer, you can use the USBCommunicator program
to disable the password to set also the target temperature for heating and cooling.
When the default screen is displayed, press the ENTER key to enter the module setting, and
select the Password menu.
Settings
Password
After opening this menu, the display shows:
Password
000000
The cursor blinks on the first digit. Use the ▼/▲ keys to set the first digit of the password and
short press the ENTER key to move to the next digit. Repeat this operation to enter all
digits of the password. After setting all digits, long press the ENTER key to confirm the set
password. If the password is correct, the following message briefly appears:
Password
Passw OK
If an incorrect password has been entered, the display shows Error and then the display
returns one level back. If the correct password has been entered, it is possible to
change the module settings for 30 minutes; then the operator is logged out. While the
log-on state remains valid, menu Password is not displayed in the main setting menu
of the SCMI-01.4 module.
-
This menu allows you to set the desired temperature in the cooling
mode.
This menu allows you to set the desired temperature in the heating
mode.
-
This menu allows you to select one of the five basic operation modes
of the control module.
-
This menu allows you to set the method and necessary parameters
to defrost the indoor unit evaporator.
-
This menu allows you to set the function and switching logic of the
output relays of the module.
-
This menu allows you to set the control constants needed for the
operation of the module.
-
This menu allows you to set the display of the control module.
-
This menu allows you to log in to set the control module. Without
logging, you can only view the set parameters and cannot change
them. After successful login, this menu is not displayed!
- 6 -