Safety Instructions - Sinclair SCMI-01.4 User Manual

2. SAFETY INSTRUCTIONS

WARNING
Please read this manual carefully before installing this device!
This manual is a part of the product and must be kept near the device to be available

to easily obtain the information.
This device is not intended to be used for other purposes than those described below.

Before starting operation, please check the range of operating conditions of the given

installation.
 The SCMI-01.4 control module may be installed only by a company that has the
relevant qualification and is authorized by the manufacturer.
This device is designed for mounting on a DIN rail in a dry and dust-free environment.

Do not allow the water to get into the electrical components; there is a risk of electric
shock or damage to the unit.
 Do not allow persons without the necessary qualification, and especially children, to
manipulate the device.
Cleaning and maintenance may only be performed by persons with the suitable

qualification. Otherwise, personal injury or property damage may occur. Do not
dismantle nor repair the device.
Disconnect the device from the power supply before cleaning or maintenance.

Otherwise, an electric shock may occur.
Do not touch the device with wet hands, do not operate it in a wet environment and

do not wash it with water. There is a risk of electric shock.
 Damaged power cables must be replaced by the manufacturer, authorized service
centre or appropriately qualified person.
Do not repair the device yourself. Otherwise, electric shock or damage to the device

may occur. Contact your dealer, if you need to repair the device.
Immediately turn off the device and disconnect it from the power supply, if any of the

following conditions occurs. Then ask your dealer or an authorized service centre for
repair. If you let the device running under these conditions, this may cause a
malfunction, electric shock or fire.
• The power cord overheats or it is damaged.
• An abnormal noise during operation.
• An upstream breaker repeatedly trips.
• The device smells like something is burning.
Ensure that the wires for sensors, load, and power supply are led separately and far

enough from each other, without crossing or parallel leading.
- 2 -