Sony 3-097-196-14(1) Operating Instructions Manual page 68

4
Press and hold BLUETOOTH

OPR
seconds until the BLUETOOTH
indicator
Sound output from the speakers is
stopped.
5
Enter the passcode.
Follow the same procedure as in
step 4 of "Pairing this system with a
Bluetooth device" (page 64).
Once pairing is completed and the
connection is established, the system
display changes as follows:
"Connect"  Name of the Bluetooth
device
To cancel passcode entry partway
Press  
.
Notes
 "Passcode" may be called "Passkey, " "PIN
code, " "PIN number" or "Password, " etc.
depending on the device.
 This system only supports numerical
passcodes up to 4 digits.
 The pairing standby status of the system is
cancelled after about 30 seconds. If pairing is
not successful, redo the procedure from step
1.
 While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.
 Pairing may not be possible if other
Bluetooth devices are present around the
system. In this case, turn off the other
Bluetooth devices.

GB
on the unit for about 7

flashes.
To erase all the pairing registration
information
1
Press FUNCTION +/
to select "BLUETOOTH" (or press
BLUETOOTH 
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2

Press CLEAR .
"Delete?" appears.
3

Press ENTER .
"Complete!" appears and all the
pairing information is erased.
Note
To connect with Bluetooth headphones after
performing this operation, you must enter the
passcode again.

repeatedly

on the unit).

on