Specifications - Sony STR-DG500 Operating Instructions Manual

PROTECT
Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 25). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U, CA
Stereo Power Output
Output
8 ohms 20 Hz – 20 kHz, THD 0.09%
8 ohms 1 kHz, THD 0.7%
8 ohms 1 kHz, THD 10%
See
page 25
Models of area code CEL, CEK, E2, TW, AU
Stereo Power Output
page 53
Output
8 ohms 20 Hz – 20 kHz, THD 0.09%
8 ohms 1 kHz, THD 0.7%
8 ohms 1 kHz, THD 10%
Models of area code SP
Stereo Power Output
Output
8 ohms 20 Hz – 20 kHz, THD 0.09%
8 ohms 1 kHz, THD 0.7%
8 ohms 1 kHz, THD 10%
1)
, Reference Power
1)2)
100 W + 100 W, 110 W/ch
110 W + 110 W, 120 W/ch
125 W + 125 W, 150 W/ch
1)
, Reference Power
1)2)
85 W + 85 W, 110 W/ch
100 W + 100 W, 120 W/ch
125 W + 125 W, 150 W/ch
1)
, Reference Power
1)2)
70 W + 70 W, 90 W/ch
80 W + 80 W, 100 W/ch
100 W + 100 W, 125 W/ch
continued
71
GB