Select Gate Using Pin Codes; Calling Select Gate From House - Select Engineered Systems Select Gate 1A User/Installer Manual

SELECT GATE SG-1A V1.X
5.4

SELECT GATE USING PIN CODES

PUSH
TO E
CALL
5.5

CALLING SELECT GATE FROM HOUSE

Pick up any Touch-Tone™ phone, wait one second and dial the remote control password
as shown below:
You have five seconds to dial in the password.
After the correct password has been entered, you will hear 1 beep (•). Now enter the
appropriate number to latch the entrance. The speaker and microphone are also active at this
time to permit conversation. Any combination of relay functions may be keyed in, until the house
phone hangs up.
SELECT ENGINEERED SYSTEMS 11/01
In addition to opening the entrance from the house or from a
remote location, Select Gate can operate the entrance from the
keypad. This is done with a PIN (Personal Identification Number)
code. This is a 4 digit number. When the "*" key is pressed, (as
shown at left) followed by the PIN code, the entrance will open.
Select
E n g i n e e r e d
Systems, Inc.
H i a l e a h , F L 3 3 0 1 6
1 ( 8 0 0 ) 3 4 3 - 5 7 3 7
In this example, a PIN code of 1234 will open the Select
Gate entrance.
There are remote control functions built into the Select Gate
that allow the entrance relay to be controlled in different ways. The
entrance may be latched in an open condition, or it may be
energized for one hour. In addition to the door open number,
(which is usually a "6") numbers may have been entered by your
installer for a latch number and a one hour number. Refer to the
Customer Setup chart in Appendix A on Pg. 33-35 for the correct
Touch-Tone™ numbers to use from your phone to energize the
relay for these functions.
In order to access these functions, the house must call the
Select Gate and enter a remote control password which is the first
2 digits of the program password, and will usually be "7 7".
If your installer has changed the password, refer to the Customer
Setup chart in Appendix A on Pg. 33-35 for the correct Remote
Control password. It will be the first two digits of the Programming
Password.
7 7
31