Channel Scan; Memory Scan - Cobra microTALK RX680 Owner's Manual

Channel Scan

Your microTALK radio can automatically scan channels.
®
To scan channels:
Scan Button
1. Press and hold the Scan button until the Scan icon and
the channel numbers appear on the display.
2. Press and hold the Scan button to begin scanning
channels.
Scan Channels
The radio will check privacy
codes while scanning channels.
The Scan icon will continue to be displayed when scan is
Up/Down Button
on. Your radio will continue to scan all channels and stop
if an incoming transmission is detected. Your radio will
remain on that channel for 5 seconds.
During scanning (while receiving an incoming transmission), you can
choose from the following:
a. Press and hold the Talk button to communicate on that channel. Your radio
will remain on that channel and return to Standby mode.
b. Press the Up or Down button to resume scanning channels.
c. Press and hold the Scan button to return to Standby.

Memory Scan

Your microTALK radio can automatically scan memory channels.
®
To scan Memory channels:
Scan Button
1. Press and hold the Scan button while you are on
Memory Standby mode until the Scan Mem icons
show on the display.
2. Press either Up or Down to begin scanning
Up/Down Button
memory channels.
The Scan Mem will continue to be displayed when scan
is on. Your radio will continue to scan all memory
channels and stop if an incoming transmission is
detected. Your radio will remain on the channel
for 5 seconds.
16
During scanning (while receiving an incoming transmission), you can
choose from the following:
a. Press and hold the Talk button to communicate on that channel. Your radio
will remain on that channel and return to Memory Standby mode.
b. Press the Up or Down button to resume scanning channels.
c. Press and hold the Scan button to return to Memory Standby.
Set High / Low (H - L) Transmit Power Level
Your radio can transmit selectively at 0.5 or 2 watts of power. Use the low
power setting for short-range communications and use the high power setting
for long-range communications.
To toggle between H - L Power Modes:
HI/LOW Button
1. Press and hold the HI/LOW button until Hi or Low
icon toggled.
Hi/Low Icon
Channel 8~14, 34~37, 53~56 only operates
on Low power setting.
17