Memory Location - Cobra microTALK RX680 Owner's Manual

10 Memory Location

radio has 10 Memory Locations for storing your most
Your microTALK ®
frequently used channels and channel/privacy code combinations.
These Memory Locations can be selected individually or can be scanned.
(See page 16 for memory location scan.)
MEM/ESC Button To program a memory location:
1. Press the MEM/ESC button. Memory icon and the
Memory Location show on the display.
2. Press the Up or Down button to select the memory
Up/Down Button
location (0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
MEM/ESC Button
3. Press the MEM/ESC button to enter a new memory
location or edit an already programmed memory
location.
Up/Down Button
4. Press the Up or Down button to select the memory
location.
5. Press the MEM/ESC button. The channel numbers will
ash on the display.
6. Press the Up or Down button to select a channel (1
Memory Channel
through 60).
7. Press the MEM/ESC button. The CTCSS icon and
privacy code numbers will ash on the display (only be
available on channel 1~22).
Up/Down Button
8. Choose one of the following:
a. Press the Up or Down button to select a CTCSS
privacy code (00 through 38) for the channel.
b. Press the MEM/ESC button to switch from CTCSS
to DCS. The DCS icon and privacy code numbers
will ash on the display. The Up or Down button
can then be used to select a DCS privacy code (00
through 83) for the channel (only be available on
channel 1~22).
14
If "oF" ashes in place of the privacy code numbers, a privacy
code is already set in the opposite (CTCSS or DCS) system. Press
the Up or Down button to cancel the opposite code and select a
privacy code from the active system for the selected channel.
9. Choose one of the following:
a. Press the MEM/ESC button to enter the channel/privacy code in the
selected memory location. Radio then proceeds to next memory
location, which will blink.
b. Press and hold the MEM/ESC button to save the current state of the
Set Memory Function and return to Standby mode.
To recall a stored memory channel location:
MEM/ESC Button
1. Press the MEM/ESC button until the Memory icon and
the memory location number ash on the display.
2. Press the Up or Down button to select a memory
location (0 through 9).
Up/Down Button
If a location has been programmed before,
its associated channel/privacy code will
be shown on the display.
Memory Channel
3. Press and hold the MEM/ESC button to return to
Standby mode on the selected memory location.
A memory location can be reprogrammed
at any time it is displayed. Press the
MEM/ESC button to begin.
15