Sony STR-DA5300ES Operating Instructions Manual page 51

Message list after auto calibration measurement
Display Explanation
Code 30 Headphones are connected. Remove the headphones and perform the auto calibration again.
Code 31 SPEAKERS (OFF/A/B/A+B) is set to OFF. Set it to others and re-perform the measurement.
Code 32 None of the speakers were detected. Make sure that the optimizer microphone is connected
properly and reperform the measurement.
If the optimizer microphone is connected properly but the error code appears, the optimizer
microphone cable may be damaged or improperly connected.
Code 33 • None of the front speakers are connected or only one front speaker is connected.
• The optimizer microphone is not connected.
• Either the left or right surround speakers is not connected.
• Surround back speakers are connected even though surround speakers are not connected.
Connect the surround speaker(s) to the SURROUND terminals.
• The surround back speaker is connected only to the SURROUND BACK SPEAKERS R
terminals. When you connect only one surround back speaker, connect it to the
SURROUND BACK SPEAKERS L terminals.
Code 34 Speakers are not placed in the proper position. Speakers or an optimizer microphone on the
right or left may be placed wrongly. See "1: Installing speakers" (page 16) and check the
speaker position.
Warning 40 The measurement has completed. However, the noise level is high. You may be able to
perform the measurement properly if you try it again, even though the measurement cannot
be performed in all environments. Try to perform the measurement in a quiet environment.
Warning 41 The sound input from the optimizer microphone is outside the acceptable range. It is louder
than the loudest sound that can be measured. Try to perform the measurement when the
environment is quiet enough to allow proper measurement.
Warning 42 The volume of the receiver is out of the acceptable range. Try to perform the measurement
when the environment is quiet enough to allow proper measurement.
Warning 43 The distance and position of a sub woofer cannot be detected. Or the angle of the speaker
position cannot be detected. This may be caused by noise. Try to perform the measurement
in a quiet environment.
Warning 44 Measurement has been completed. However the speakers are not placed in the proper position
with respect to each other. See "1: Installing speakers" (page 16) and check the relative
positions of the speakers.
NO WARNING There is no warning information.
---------- No speakers are connected.
•Code 31
1
Press , then follow the instructions from step
1 of "Performing auto calibration."
•Code 32, 33, 34
1
When you press , "Retry?" appears.
2
Press B/b to select "Yes," then press
3
Follow the instructions from step 2 of
"Performing auto calibration."
When you select "WRN CHECK"
If a warning on the measurement result is
present, detailed information is displayed.
Press
"Confirming/saving the measurement
results" (page 49).
.
to return to step 1 of
continued
51 GB