FSP Technology iFP 600 Manual Manual

Installation & Operation

Inspection
•
The following items are inside the box:
●UPS unit & User manual
•
Remove the UPS from its package and inspect it for damage that
may have occurred during shipping. If any damage is discovered,
re-pack the unit and return it to the place of purchase.

Connect to Utility Power
•
Connect AC power cord to utility power. Then, the UPS will start
to charge inside battery. For best result, charge the battery for 6
hours prior to initial use.

Plug in Equipment
•
Plug your equipment to Battery Backup Outlets on the rear panel
of the UPS.
•
NOTE: Make sure that the UPS is powered on to protect all
important devices from data loss during power failure.
•
CAUTION: NEVER connect a laser printer or scanner to the
battery backup outlets of UPS. The equipment may draw
significantly power to overload the UPS.

Turn On/Off the UPS
•
Please transport the UPS system only in the original package to
protect against shock and impact.

Rear Panel

A: Outlets
B: AC input
C: Fuse/Breaker
D: USB port
E: Surge protection
FSP Manual Guide
400-800VA
1000VA
1500-2000VA

LCD Display

Operation Display
UPS LCD
mode
UPS
Power
on
AC Mode
When AVR is functioning,
icon will flash every
second.
Overload
in AC
mode
icon will flash.
Battery
Mode
When battery level is low,
icon will flash.
Overload
in battery
mode
icon will flash.
NOTE: If backlight shuts off, you may activate it by touching the screen.
Fault Code Table:
Fault condition LCD
Output short
circuited
Overload fault
Overcharge
Bad/severely
discharged
battery
High output
voltage fault
Over-
temperature
If fault alarm occurs, please call for service immediately.
Line-interactive UPS
iFP 600VA~2KVA
Description
When UPS is powered on, it
will enter this mode for 4
seconds.
LCD information will be
displayed in the following
order when LCD is touched.
1.Output voltage
2.Input voltage
3.Load level
4.Battery capacity
When overload occurs,
alarm will beep every 0.5
second.
Alarm will beep every 10
seconds and LCD
information will be displayed
in the following order when
LCD is touched.
1.Output voltage
2.Input voltage
3.Load level
4.Battery capacity
When overload occurs,
alarm will beep every 0.5
second.
Solutions
Disconnect short-circuited loads and
restart the UPS again.
Disconnect all output loads and
restart the UPS again.
Call for service immediately.
Please replace the battery.
Call for service immediately.
Call for service immediately.