LG PQNFB17C1 Installation & Owner's Manual page 6

IMPORTANT SAFETY INSTRUCTIONS
iv
Do not install the product at wet place.
- It may cause failure of the product.
Provided product and adaptor shall only be installed and used inside a building.
- It may cause fire or failure of the product.
*Do not install or use outside.
Install stably in a place that can endure the weight of the ACP BACnet.
- If the installation place is not strong enough, the ACP BACnet may fall and damaged.
Make sure to enquire to the specialty store of the product purchase or service center for
electric works.
- It may cause fire or electric shock.
Do not damage the power cord or bend it by force.
- It may cause fire or electric shock.
You need to use a safely insulated power supply which follows IEC61558-2-6 and NEC
Class2
- If you do not follow, It may cause fire, electric shock, explosion or injury.
Do not connetion 220 V power to 24 V products
- If you do not follow, It may cause fire, electric shock, explosion or injury.
Do not connect power cord to the control signal connector.
- It may cause fire or explosion.
Fix cables tightly when wiring power cord, communication wires and etc.
- Fire or electric shock accidents can occur if cables are loose.
Prepare adequate protection equipment for noise when carrying out installation in places
like hospitals or communication base stations.
- The product can be broken or other products can work abnormally.
Operation
Do not change or extend the power cord with your own discretion.
- It may cause fire or electric shock
Do not place any heating device near the product.
- It may cause fire.
Do not use any heating device near the power cord.
- It may cause fire or electric shock.
Do not let water flow into the product.
- It may cause electric shock or failure.
Do not put heavy weight on the power cord.
- It may cause fire or electric shock.