Sony STR-DA4ES Operating Instructions Manual page 74

Listening to the sound in another room (continued)
Audio/Video components
To change button assignments for
the 2nd room mode
When the remote is set to the 2nd room mode,
you can set the remote to turn the receiver
on/off or adjust the volume.
You can assign the following buttons:
?/1, MUTING, MASTER VOL +, MASTER
VOL –
Example: To set the command mode of above 4
buttons to "AV SYSTEM 1" while in the 2nd
room mode.
1
Press USE MODE more than 2 seconds.
The indicator remains lit.
2
Press 2ND ROOM.
3
Press AV SYSTEM 1.
4
Press SOURCE.
The indicator slowly lights up twice, then
goes off.
For the above 4 buttons, the signals for AV
SYSTEM 1 are output even in the 2nd room
mode. Besides, you can operate the receiver
whose command mode is "AV SYSTEM
1".
To change assignments for the 3rd
room.
Press 3RD ROOM in step 2.
GB
74
Main room
AV SYSTEM 2
+
–
– +
STR-DA7ES
2ND or
Speaker
3RD
ROOM
OUT
Note
To reset the assignments of ?/1, MUTING,
MASTER VOL +, MASTER VOL –, press 2ND
ROOM (during 2nd room mode) or 3RD ROOM
(during 3rd room mode) in step 3. Or, clear all remote
button assignments (page 00), then perform the
procedures on page 00 or 00.
To set the remote RM-US105A not to
adjust the volume in the 2nd (or 3rd)
room
Press the following buttons in step 3:
• 3RD ROOM (during 2nd room mode)
• 2ND ROOM (during 3rd room mode)
You cannot use ?/1, MASTER VOL +,
MASTER VOL – on the remote RM-US105 to
operate the amplifier in the 2nd (or 3rd) room.
2nd (or 3rd) room
AV SYSTEM 1
Monitor
Speaker
Receiver
(STR-XXXX)