Sony STR-DA4ES Operating Instructions Manual page 62

CONTROL A1 /S-LINK control
system (continued)
CONTROL A1
compatibility
The CONTROL A1 control system has been
updated to the CONTROL A1 which is the
standard system in the Sony 300 disc CD changer
and other recent Sony components. Components
with CONTROL A1 jacks are compatible with
components with CONTROL A1 , and can be
connected to each other. Basically, the majority of
the functions available with the CONTROL A1
control system will be available with the
CONTROL A1 control system.
However, when making connections between
components with CONTROL A1 jacks and
components with CONTROL A1 jacks, the
number of functions that can be controlled may be
limited depending on the component. For detailed
information, refer to the operating instructions
supplied with the component(s).
CONTROL A1
• If you have a CONTROL A1
Sony CD player, Super Audio CD player,
tape deck, or MD deck
Use a CONTROL A1 cord (mini jack) (not
supplied) to connect the CONTROL A1
jack on the CD player, Super Audio CD
player, tape deck, or MD deck to the
CONTROL A1
page 61 and the operating instructions
supplied with your CD player, Super Audio
CD player, tape deck, or MD deck for
details.
Note
If you make CONTROL A1 connections from
the receiver to an MD deck that is also connected
to a computer, do not operate the receiver while
using the "Sony MD Editor" software. This may
cause a malfunction.
GB
62
and CONTROL A1
hookup
compatible
jack on the receiver. See
• If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer's COMMAND MODE
selector can be set to CD 1, CD 2, or CD 3,
be sure to set the command mode to "CD 1"
and connect the changer to the CD jacks on
the receiver.
If, however, you have a Sony CD changer
with VIDEO OUT jacks, set the command
mode to "CD 2" and connect the changer to
the VIDEO 2 jacks on the receiver.
Connections
Connect monaural (2P) mini-plug cords in
series to the CONTROL A1
back of each component. You can connect up
to 10 CONTROL A1
in any order. However, you can connect only
one of each type of component (i.e., 1 CD
player, 1 MD deck, 1 tape deck and 1 receiver).
(You may be able to connect more than one CD
player or MD deck, depending on the model.
Refer to the operating instructions supplied
with the respective component for details.)
Example
Amplifier CD MD
(Receiver) player deck
In the CONTROL A1
control signals flow both ways, so there is no
distinction of IN and OUT jacks. If a
component has more than one CONTROL
A1 jack, you can use either one, or connect
different components to each jack.
jacks on the
compatible components
Tape Other
deck component
control system, the