Getting Started - Sony STR-D760Z Operating Instructions Manual

To return to the main menu
Click EXIT.
To return to a previous menu
Click RETURN.
To register special IR codes that do not appear as on-
screen controls
See "Registering Desired Components (User IR setting)" on
page 42.
Notes
• If the IR codes do not operate as expected, perform the
registration operation(s) again to make sure the IR codes
are registered correctly. If the IR code still cannot be
registered, see "Registering Desired Components (User IR
setting)" on page 42.
• If you experience difficulty operating the INPUT, number,
or ENTER buttons of a VCR or LD player after automatic
registration in step 5, register the IR codes for that
component manually as shown in step 6.
• When using components made by other manufacturers,
certain operations may not be possible even after selecting
manufacturer (in step 5). In this case, register the IR codes
for those buttons manually as shown in step 6.
• If you register a playback source as TOSHIBA 2 or RCA 2,
you cannot turn the TV on or off using the receiver's
remote (the power will not go on when you click TEST).
• Do not register the same type of component (e.g., an LD
player) at several different functions.
• You can register about 200 IR codes, including user IR
codes (see page 42); however, depending on the type of
codes recorded, the maximum limit may be less than 100.
It may be difficult or impossible to register about 200
codes under the following conditions:
-When registering from remotes with weak batteries.
-When registering IR codes that have been registered to a
programmable remote (e.g., any IR code not originally
supplied in the respective remote).
• Keep the IR sensor away from fluorescent light or direct
sunlight. Otherwise, the IR codes may not be registered.
• If the AC power cord is disconnected for about two
weeks, the registered IR codes will be erased. "ALL
CLEAR!" will appear on the TV screen the next time you
turn on the receiver.
• Some remote controls supplied with audio and video
components made by other manufacturers may have a
special formats. In such cases, it may not be possible for
the receiver to learn (or properly execute) their command
codes.
Setting Up the Remote for On-Screen Control
Erasing IR codes
Click CODE CLEAR in the IR CODE SETTING menu
that appears when you click START.
• To erase a specific IR code
1 Click SINGLE IR CODE CLEAR.
"SELECT CLEAR CODE KEY" appears.
2 Click the button you want to clear.
"Are you sure?" appears.
3 Click YES to erase the code.
"CODE CLEAR!" appears.
To cancel erasing, click NO.
To erase another code repeat steps 2 and 3.
• To erase all the IR codes for the current component
(e.g., OTHER CD)
1 Click (OTHER CD) CODE CLEAR.
"Are you sure?" appears.
2 Click YES to erase the codes.
"CODE CLEAR!" appears.
To cancel erasing, click NO.
• To erase all the IR codes
1 Click ALL IR CODE CLEAR.
"Are you sure?" appears.
2 Click YES to erase the codes.
"CODE CLEAR!" appears.
To cancel erasing, click NO.

Getting Started

21