Sony STR-D760Z Operating Instructions Manual page 20

Setting Up the Remote for On-Screen Control
5
Click the respective component.
MAKER
OUTPUT
VCR
TV
RETURN
• If the component is not a VCR or laser disc
player
1 Cover the IR sensor on the component to
prevent accidental operation during the
registration procedure.
2 Click START, then go to step 6.
• If the component is a VCR, DVD or laser disc
player:
1 Click START.
A list of other manufacturers appears.
RETURN
2 Click the manufacturer of the component you
want.
The IR codes for that component are
automatically registered.
EMERSON
FISHER
PANASONIC
TOSHIBA
MITSUBISHI
GRUNDIG
HITACHI
PHILIPS
RETURN
If the manufacturer is not listed, cover the IR
sensor on the component to prevent accidental
operation during the registration procedure,
click OTHER, then go to step 6.
20
IR CODE SETTING
Sony OTHER
IR
DVD TAPE
LD DAT
CD MD
START EXIT
LD DAT
CD MD
START EXIT
VCR MAKER SETTING
1 2 3 4 AKAI 1 2
1 2 3 GE 1 2
1 2 JVC 1 2
1 2 RCA 1 2
1 2 3 SANYO 1 2
SHARP
ZENITH
OTHER
TEST
EXIT
3 Click TEST.
If the selected component turns on, the IR
codes have been registered. The registration is
complete.
If the component does not turn on:
Click the number button beside the
manufacturer's name to select another number,
then click TEST again.
If the component still does not turn on:
Cover the IR sensor on the component to
prevent accidental operation during the
registration procedure is complete, click
OTHER, then go to step 6.
6
When "PUSH YOUR REMOTE" appears, press
the button on your audio/video component's
remote that corresponds to the control button
highlighted.
is the POWER switch.
After you have registered all the IR codes, the IR CODE
SETTING menu reappears.
IR CODE SETTING
0 ( ) p
2 3 4 5
10/0 >10 DISC
D. SKIP
PUSH YOUR REMOTE
RETURN
When registering the IR code, be sure to do the
following; otherwise, the IR code may not be
registered correctly.
• Point the remote at the IR sensor on the
receiver from a distance of less than 2 inches (5 cm).
• Hold down the button on the remote for about 2 or 3
seconds until the "RECEIVING" display switches to
"RELEASE YOUR REMOTE".
• Keep the remote pointed horizontally at the IR sensor
until the code is registered.
7
Repeat steps 3 to 6 to register IR codes from other
components.
1
P = +
6 7 8 9
TRACK ENTER
CODE CLEAR
EXIT
IR sensor
audio/video component's
remote