Speaker System Hookups - Sony TA-VE810G Operating Instructions Manual

c DAT/MD (to DAT/MD deck)
Amplifier
RECOUT IN
L
R
DAT / MD
d TUNER (to a tuner)
Amplifier
IN
L
R
TUNER
e PHONO (to a turntable)*
Amplifier
L
R
PHONO
* If your turntable has an earth lead, connect it to y
SIGNAL GND on the unit to prevent hum.
z
To use Sony components with a CONTROL A1
terminal
You can connect a CONTROL A1 compatible Sony CD
player, tape deck or MD deck to the amplifier. Use a
CONTROL A1 cord (not supplied) to connect the CTRL
A1 jack on each component to the S-LINK CTRL A1 jack
on the amplifier. See the instructions for each
component.
z
You can display the operating status of the
component connected to the CTRL A1 jack
See page 41.
z
To use a Sony CD changer with a COMMAND MODE
selector
• If the changer does not have a VIDEO OUT jack, set
the command mode to "CD 1" and connect the
changer to the CD jack on the amplifier.
• If the changer has a VIDEO OUT jack, set the
command mode to "CD 2" and connect the changer
to the VIDEO 1, VIDEO 2, or LD jack on the amplifier.
DAT/MD
OUTPUT INPUT
LINE LINE
L
R
Tuner
OUTPUT
LINE
Turntable
OUTPUT
Hooking Up the System

Speaker System Hookups

Although front (left and right) speakers are required,
centre and rear speakers are required only for enjoying
surround sound.
What cords will I need?
Speaker cord (not supplied)
(+)
(–)
Twist the stripped ends of the cord about 2/3 inch (15
mm). Be sure to match the speaker cord to the
appropriate terminal on the components: + to + and –
to –. If the cords are reversed, the sound will be
distorted and will lack bass.
Rear Rear
speaker (L) speaker (R) Amplifier
SURROUND SPEAKERS
R
+
-
R
WOOFER
AUDIO
OUT
Front speaker (R)
+ - -
A
R
+ - -
B
IMPEDANCE USE 4-16
FRONT SPEAKERS
Getting Started
(+)
(–)
Centre
speaker
REAR L CENTER
+
-
L
IMPEDAMCE USE 4-16
Front speaker (L)
+
A
L
+
B
(continued)
GB
7